Jump to content

Thebiochemist

Members*
  • Content Count

    15
  • Joined

  • Last visited

Community Reputation

4 Neutral

Profile Information

  • State and Country Flags
    Arizona

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Jeez, where are you? State wise man. This is painful to watch haha Sent from my Pixel 4 using Tapatalk
  2. Lol he had no idea that it's just to house the trigger until you move it to a real lower? Wut. Old maybe? Welp Sent from my Pixel 4 using Tapatalk
  3. Ahhh I see. Once you have the proper tools, it's not that bad for the lower but I hear you. There's some things I won't do to my jeep and my guns. knowing your own limitations is important Sent from my Pixel 4 using Tapatalk
  4. Also, good choice. I've assembled three friends ARs with that kit. It's very very nice shooting Sent from my Pixel 4 using Tapatalk
  5. It's used by gun shops to allow testing of the AR trigger/safety combos. That way you don't need an upper and lower. Cost savings Sent from my Pixel 4 using Tapatalk
  6. I have the same mods on my tj ha ha. Core 4x4 front and rear track bar, magnaflo complete exhaust (hooker header though), bds 2 inch lift, power stop front brake kit, etc. Sent from my Pixel 4 using Tapatalk
  7. Welcome to the club. I love my Jeep, had one since I was 16. They're great. Just remember... It's never done. Sent from my Pixel 4 using Tapatalk
  8. I assembled a larue lower for my boss and tested it with him there after. The larue trigger is slick and feels the trigger surface is thicker than average and free of hit spots. It's well worth the money imo. I also have access to a hiperfire if you have questions on that [emoji2371]. Would have to go shooting w my buddy to try it so it'd take a bit as I work odd hours during the week. Sent from my Pixel 4 using Tapatalk
  9. Ok cool. Sent from my Pixel 4 using Tapatalk
  10. I understand that they're flip ups, that wasn't my question. I meant don't they easily fold down rather having a stuff detent? Sent from my Pixel 4 using Tapatalk
  11. Don't KAC sights not lock in the open position? Sent from my Pixel 4 using Tapatalk
  12. Best is so subjective but... Check out gg&g... And bcm. There's a slew of them, I'm sure you'll get a lot of replies. Sent from my Pixel 4 using Tapatalk
  13. If you just have a stripped lower, I'd highly recommend buying a larue kit. Its tail causes very little interference with the barrel (if any at all) and the price is hard to beat. Sent from my Pixel 4 using Tapatalk
  14. I have a geissele SD-C and a timney targa. Both are two stage and I honestly wouldn't have it any other way at this point. I've tried many others but these happen to my favorite. Sent from my Pixel 4 using Tapatalk
  15. There's a company that sells Cerro forgings... that's the forging house that does Colt receivers unless I'm mistaken. https://www.righttobear.com/cerro-forge-raw-80-percent-lower-receiver-p/80raw-1.htm Keep in mind, you'll most likely have to anodize your own lower as places won't do it for you due to lack of serial number. Anodization helps with the alluminium strength. Sent from my Pixel 4 using Tapatalk
×
×
  • Create New...