Jump to content
AR15Armory.com

KYDEX HOLSTER & SHEATH MAKING


hkriflenut
 Share

Recommended Posts

the side that has the mount allows the pistol enough room to draw it. the trigger guard and the non mount side provide plenty of rentention. i need a shorter screw though to get it to be a hair tighter. i just need to cut one.

 

all i did was spot heat it with the heat gun to remove the definition after molding.

When I mold a j frame, I have a short length of dowel rod cut in half lengthwise and milled to fit over the cylinder release. It creates a seemless opening around the cylinder without the need to reheat the the sweat shield.

Link to comment
Share on other sites

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...